|
[Sponsors] |
May 22, 2024, 19:07 |
Heat flux w/m2 on coupled boundary
|
#1 |
New Member
Ibrahim I
Join Date: Feb 2024
Posts: 6
Rep Power: 2 |
Hello, I am doing a cht case of a sealed trombe wall. I have a coupled boundary between air and a solid, but I also need a heat flux w/m2 applied on the solid boundary (to simulate solar flux). Is there a simple way to do this? Currently I've split the solid into a really thin part and a larger part, and am applying a w/m3 to the thin part to emulate a w/m2 on that boundary whilst also keeping it coupled.
Kind regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
reverse flow in centrifugal fan blades | kalm | CFX | 20 | December 2, 2023 06:25 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
CFX13 Post Periodic interface | EtaEta | CFX | 7 | December 8, 2011 17:15 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |