|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Sebastian
Join Date: Jan 2022
Location: Germany
Posts: 12
Rep Power: 4 ![]() |
Hey everyone,
I am currently working on a case where I am simulating a flow through a duct. In this case, an entrance length is taken into account in which the flow is first formed before it flows into the actual duct. Currently I simulate the entrance length (which is about 5 times as long as the actual duct) with every simulation, but I was wondering if it would be possible to take the flow field after the entrance length and use this as a new inlet/boundary condition for the actual duct in my /0 folder. So I would have the formed flow profile at the actual inlet of my flow and could remove the duct for the entrance length from the simulation again. However, I haven't figured out how to tap my values for U, p, k, ... at a cross-sectional area to use that as a nonuniform inlet condition. I would be glad if someone could help me further. Sebastian |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
duct simulation in su2 | bala732 | SU2 | 1 | October 4, 2017 10:06 |
How can I calculate the Metallurgical length of a continuous casting simulation? | Murshi09 | FLUENT | 0 | April 22, 2016 02:43 |
Modelled Length Scale in SAS-SST Simulation | jego | Main CFD Forum | 0 | January 16, 2016 06:45 |
Duct case setup - Fan simulation | nkjsimulating | Main CFD Forum | 0 | October 10, 2013 04:15 |
entrance length | hamid1 | FLUENT | 3 | February 10, 2013 06:27 |