 |
 |
 |
|
|
|
[Sponsors] | ||||
help!!problem in openfoam when i use icem mesh file with cyclic boundary condition |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 3, 2020, 23:06
|
help!!problem in openfoam when i use icem mesh file with cyclic boundary condition
|
#1 |
|
New Member
wangh
Join Date: Jul 2020
Posts: 10
Rep Power: 6  |
my openfoam version is 2.0
when i use ansys icem make a mesh file and fluent3DMeshToFoam,is ok. but the solver cannot keep going,it print this: FAOM FATAL ERROR: face 9912 area does not matchneighbor by 9.142%--possible face ordering problem . this face area is the boundary which i set cyclic condition . though i used createPatch code,it does not work,the same problem it print out. please help me |
|
|
|
|
|
| Tags |
| cyclic boundary condition, icem, mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 22:53 |
| [OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 04:23 |
| DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 02:24 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 18:51 |
Linear Mode
