 |
 |
 |
|
|
|
[Sponsors] | ||||
June 21, 2019, 14:23
|
HELP!!! OpenFoam-6 checkMesh take long time
|
#1 |
|
New Member
Dongchen Wang
Join Date: Jun 2016
Posts: 1
Rep Power: 0  |
I have both OpenFoam-6 and OpenFoam-v1812 installed on my computer.
A hexahedra mesh, about 13 million elements. When I run checkMesh in v1812 environment, the process finished within few minute. But when run checkMesh in OpenFoam-6 environment, it stuck at stage shows below and never finish. Checking topology... Boundary definition OK. Cell to face addressing OK. Point usage OK. Upper triangular ordering OK. Face vertices OK. Did anyone have the same issue? Can anyone explain the reason? Thanks!!! |
|
|
|
|
|
June 27, 2019, 05:46
|
|
#2 |
|
Senior Member
Zander Meiring
Join Date: Jul 2018
Posts: 125
Rep Power: 8 |
I found OF5 to be significantly slower with checkMesh than OF1806. I imagine their next iterations follow the same trend. It's just part of what's different between the softwares
|
|
|
|
|
|
 |
| Tags |
| checkmesh issue |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| courant number increases to rather large values | 6863523 | OpenFOAM Running, Solving & CFD | 22 | July 6, 2023 00:48 |
| AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 05:13 |
| LES, Courant Number, Crash, Sudden | Alhasan | OpenFOAM Running, Solving & CFD | 5 | November 22, 2019 03:05 |
| Stuck in a Rut- interDyMFoam! | xoitx | OpenFOAM Running, Solving & CFD | 14 | March 25, 2016 08:09 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 16:33 |
Linear Mode
