Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Pre-Processing

Access files in FaceSet

Updated Threads

Reply

Search this Thread

February 15, 2018, 06:15	Access files in FaceSet	#1
SWAPNASRITA New Member odisha Join Date: Dec 2016 Posts: 8 Rep Power: 10	Hi, I have a faceset c0 containing some internal faces as well. I need to access it in lagrangian Wall Collision model. How to loop through all the faces contained in this faceset?? I have read some threads related to Hashset but couldn't understand. Thanks Sangita ** To clarify or give more information, I need to separate a patch into smaller groups and access them at the same time. Last edited by SWAPNASRITA; February 22, 2018 at 06:16. Reason: more Information

Reply

Tags

faceset, openfoam

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Meshing 3D volume from STL/STEP Files (Gmsh)	jgross	OpenFOAM Meshing & Mesh Conversion	6	July 15, 2022 06:11
[General] Accessing files from a network drive	Ramsky	ParaView	1	October 7, 2016 08:23
Compiled library vs. inInclude Files, DSMC solver crashes after run	GPesch	OpenFOAM Programming & Development	8	April 18, 2013 08:17
[swak4Foam] Mass flow rate through faceSet using swak4foam	CedricVH	OpenFOAM Community Contributions	5	May 4, 2012 08:57
Results saving in CFD	hawk	Main CFD Forum	16	July 21, 2005 21:51

All times are GMT -4. The time now is 12:38.