 |
 |
 |
|
|
|
[Sponsors] | ||||
May 24, 2017, 15:21
|
OpenFOAM Parallel Error
|
#1 |
|
New Member
Oğuzhan Demir
Join Date: Dec 2016
Posts: 19
Rep Power: 9  |
Hi everyone,
I am trying to run a parallel simulation in OpenFOAM. When i choose 56 processors, i get the following error. When i use 28 processors, it works just fine. But for some reason, i can not use 56 processors for analysis. ''/***/***/***/***/system/decomposeParDict" specifies 56 processors but job was started with 28 processors. Is there anyone who could help me with this problem? Thx in advance. Oguz |
|
|
|
|
|
May 29, 2017, 14:35
|
|
#2 |
|
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 25 |
Is this on a cluster? How are you submitting the job?
It's suspicious that 28*2=56. So some script somewhere is doing something wrong with a factor of 2. |
|
|
|
|
|
|
May 29, 2017, 15:01
|
|
#3 |
|
New Member
Oğuzhan Demir
Join Date: Dec 2016
Posts: 19
Rep Power: 9 |
Hi, thanks for the interest.
The problem was on the compiler. After I have re-installed the compiler, the problem is solved. Sent from my iPhone using CFD Online Forum mobile app |
|
|
|
|
|
 |
| Tags |
| decomposepar, error, openfoam, parallel |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 14:21 |
| OpenFOAM v3.0+ ?? | SBusch | OpenFOAM | 22 | December 26, 2016 15:24 |
| DPM udf error | haghshenasfard | FLUENT | 0 | April 13, 2016 07:35 |
| Mesquite - Adaptive mesh refinement / coarsening? | philippose | OpenFOAM Running, Solving & CFD | 94 | January 27, 2016 10:40 |
| Compiling dynamicTopoFvMesh for OpenFOAM 2.1.x | Saxwax | OpenFOAM Installation | 25 | November 29, 2013 06:34 |
Linear Mode
