|
[Sponsors] |
December 6, 2016, 09:12 |
Adiabatic surface
|
#1 |
New Member
Mattias Ström
Join Date: Dec 2016
Posts: 3
Rep Power: 9 |
Hello!
Iḿ working with the steckler case and want to give the walls and ceiling the properties of an adiabatic surface, do any one know how to proceed? |
|
December 13, 2016, 12:43 |
|
#2 |
Member
Joshua
Join Date: Dec 2016
Location: St. Louis, Missouri
Posts: 91
Rep Power: 9 |
To have no heat transfer for those walls just give them the T(temperature) boundary condition of zeroGradient.
I hope this works for you. Joshua |
|
December 15, 2016, 08:53 |
|
#3 |
New Member
Mattias Ström
Join Date: Dec 2016
Posts: 3
Rep Power: 9 |
Thanks Joshua14, zeroGradient was the solution!
|
|
Tags |
adiabatic surface, firefoam |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 12:05 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 11:49 |
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 08:05 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 13:43 |
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 07:47 |