|
[Sponsors] |
October 24, 2016, 09:58 |
noSlip or fixedValue
|
#1 |
Senior Member
Join Date: Mar 2016
Location: Bergamo
Posts: 157
Rep Power: 10 |
Hello to all,
just a simple (and maybe stupid) question. Is there any differences between the noSlip boundary condition and the following one? Code:
type fixedValue; value uniform (0 0 0); |
|
October 25, 2016, 01:16 |
|
#2 |
Senior Member
Join Date: Aug 2013
Posts: 407
Rep Power: 16 |
Hi,
I could be mistaken, but if I remember correct, noSlip is a recent introduction (seems to be from OF 4) that is supposed to do the same thing as fixedValue (0 0 0)... Link: https://github.com/OpenFOAM/OpenFOAM...98d0b13f22b515 Cheers, Antimony |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Issue symmetryPlane 2.5d extruded airfoil simulation | 281419 | OpenFOAM Running, Solving & CFD | 5 | November 28, 2015 13:09 |
my first Natural Ventilation case with OpenFOAM | alessandro.zomparelli | OpenFOAM Running, Solving & CFD | 3 | April 1, 2015 10:16 |
Problem where FixedValue Inlet meets noSlip Wall | VSass | OpenFOAM Pre-Processing | 0 | May 31, 2013 05:13 |
[swak4Foam] Air Conditioned room groovyBC | Sebaj | OpenFOAM Community Contributions | 7 | October 31, 2012 14:16 |
FOAM FATAL IO ERRORsimpleFoam | hariya03 | OpenFOAM Running, Solving & CFD | 6 | July 16, 2008 08:03 |