|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Soeren
Join Date: Oct 2012
Posts: 11
Rep Power: 14 ![]() |
Hi OpenFoam Users,
I just switched to the new version of OpenFoam and actually everything works for me besides checkMesh. It tells me that I have a high non-orthogonality, which might be the case since I am using gmsh. But, check the attached picture which show the isolated faces. This happens after I use createPatch to generate my cyclics. Before using it checkMesh does not complain. Do I miss something? cheers, Soeren ![]() |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] checkMesh Erros after refineMesh | mgdenno | OpenFOAM Meshing & Mesh Conversion | 10 | October 14, 2014 06:16 |
checkMesh Errors after refineMesh | mgdenno | OpenFOAM | 0 | July 30, 2012 22:39 |
[Commercial meshers] checkMesh : Mesh non orthogonality | Gearb0x | OpenFOAM Meshing & Mesh Conversion | 2 | February 2, 2011 11:51 |
Cyclic BCs using createPatch in OF 1.6.x | SunnyPP | OpenFOAM | 2 | August 6, 2010 11:21 |
Orthogonality Angle | Tristan | CFX | 2 | December 2, 2008 13:11 |