Check Mesh failed

mariagrazia87 · May 30, 2013, 10:28

Hi,

I created a 3D Mesh in Salome, but when I type: "checkMesh -allGeometry -allTopology" in OpenFoam it says 1 checkMesh failed.

I attach here the Error Message.

Can anybody help me to find it out?

Thank you in advance.

Mary

nimasam · May 31, 2013, 04:10

Quote:

Cells with small determinant found, number of cells: 78
<<Writing 78 under-determined cells to set underdeterminedCells

Dear maria you can see those under-determined cells!

in paraview, type
paraFoam then click on include set , then you would find where the problem is

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Foam::error::printStack(Foam::Ostream&) with simpleFoam -parallel	U.Golling	OpenFOAM Running, Solving & CFD	52	September 23, 2023 04:35
mesh check failed / degenerated contact points	shohin	FLUENT	16	April 11, 2014 23:32
[ICEM] Understanding check mesh output	kotimari	ANSYS Meshing & Geometry	0	July 15, 2012 09:33
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 19:10
user defined function	cfduser	CFX	0	April 29, 2006 11:58