How to export the specific heat and viscosity for postprocessing (compressible) ?

david39 · February 1, 2010, 14:28

Hello,

I am new in the OpenFOAM world so please apology if my question is simple.

I have tried to setup a compressible simulation by using the janafThermo and sutherlandTransport model in order to make the specific heat and viscosity depending on the temperature.

As the results I got are incorrects, I presume that there is a problem with my setup and I would like to export the Cp and viscosity for the postprocessing in Paraview in order to check that my definitions for the specific heat and viscosity in OpenFOAM (Units, ...) are correct.

How can I ask OpenFOAM for exporting the specific heat and viscosity for postprocessing purpose in Paraview ?

It would be nice if someone could help me.

Thanks,
David

foamuser99 · July 19, 2012, 21:10

Did you ever find out the answer to this question?

calf.Z · January 4, 2019, 08:04

I am also curious about this question. Can someone resolve it? Thank you.

February 1, 2010, 14:28	How to export the specific heat and viscosity for postprocessing (compressible) ?	#1
david39 New Member Join Date: Jan 2010 Posts: 7 Rep Power: 16	Hello, I am new in the OpenFOAM world so please apology if my question is simple. I have tried to setup a compressible simulation by using the janafThermo and sutherlandTransport model in order to make the specific heat and viscosity depending on the temperature. As the results I got are incorrects, I presume that there is a problem with my setup and I would like to export the Cp and viscosity for the postprocessing in Paraview in order to check that my definitions for the specific heat and viscosity in OpenFOAM (Units, ...) are correct. How can I ask OpenFOAM for exporting the specific heat and viscosity for postprocessing purpose in Paraview ? It would be nice if someone could help me. Thanks, David

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 01:58
CFX doesn't continue calculation...	mactech001	CFX	6	November 15, 2009 22:25
Concentric tube heat exchanger (Air-Water)	Young	CFX	5	October 7, 2008 00:17
Two-Phase Buoyant Flow Issue	Miguel Baritto	CFX	4	August 31, 2006 13:02

July 19, 2012, 21:10		#2
foamuser99 New Member Join Date: Jul 2012 Posts: 1 Rep Power: 0	Did you ever find out the answer to this question?

January 4, 2019, 08:04		#3
calf.Z Senior Member Jianrui Zeng Join Date: May 2018 Location: China Posts: 157 Rep Power: 8	I am also curious about this question. Can someone resolve it? Thank you.