FluentToFoam

paka · August 13, 2007, 21:10

Hi everyone,

In my research I had to import the previously created model from Fluent to OpenFOAM.

The Fluent model was created in 2D. After conversion to OpenFOAM the model depth in z-direction is 0.540534 (+-0.270267).

Can anyone explain why this happens? Why the uniform depth 1.0 is not assumed?

Is there any way to change that 0.54 depth to 1.0? I do not want to/cannot use Fluent at the moment, so I want to be able to do everything in OpenFOAM.

Thanks,
Krystian

lucchini · August 14, 2007, 07:53

Krystian,

use the transformPoints utility and you will get what you need.

Regards,

Tommaso

August 13, 2007, 21:10	Hi everyone, In my research	#1
paka Senior Member Join Date: Mar 2009 Posts: 225 Rep Power: 18	Hi everyone, In my research I had to import the previously created model from Fluent to OpenFOAM. The Fluent model was created in 2D. After conversion to OpenFOAM the model depth in z-direction is 0.540534 (+-0.270267). Can anyone explain why this happens? Why the uniform depth 1.0 is not assumed? Is there any way to change that 0.54 depth to 1.0? I do not want to/cannot use Fluent at the moment, so I want to be able to do everything in OpenFOAM. Thanks, Krystian

August 14, 2007, 07:53	Krystian, use the transfor	#2
lucchini Member Tommaso Lucchini Join Date: Mar 2009 Posts: 87 Rep Power: 17	Krystian, use the transformPoints utility and you will get what you need. Regards, Tommaso

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FluentToFoam model thickness	paka	OpenFOAM Post-Processing	0	August 9, 2007 21:20
[Commercial meshers] Defining new faces after fluenttofoam conversion	mayank	OpenFOAM Meshing & Mesh Conversion	3	June 4, 2007 11:13