|
[Sponsors] |
June 23, 2023, 09:09 |
wallHeatFlux function returns zeros
|
#1 |
New Member
Alexey Olkhovikov
Join Date: Feb 2023
Posts: 1
Rep Power: 0 |
Hello OpenFoamers!
I am quite new in Openfoam and trying to setup radiation heat transfer case using viewFactor model. I was able to run simulation successfully, but wallHeatFlux function specified in controlDict returns zeros for min/max/integral heat fluxes on the hotWall. Could you please suggest where I am wrong with my case setup? Case setup is attached. Thanks in advance for any help! |
|
Tags |
heat and mass transfer, view factor model, wallheattransfer |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] refineWallLayer Error | Yuby | OpenFOAM Meshing & Mesh Conversion | 2 | November 11, 2021 12:04 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 10:56 |
ParaView for OF-1.6-ext | Chrisi1984 | OpenFOAM Installation | 0 | December 31, 2010 07:42 |
Compilation errors in ThirdPartymallochoard | feng_w | OpenFOAM Installation | 1 | January 25, 2009 07:59 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 21:50 |