Converting multi zone date to ensight error -- CFD Online Discussion Forums

June 4, 2017, 22:32	Converting multi zone date to ensight error	#1
peterhess Senior Member Peter Hess Join Date: Apr 2011 Location: Austria Posts: 250 Rep Power: 17	Hello everybody! I face a problem converting data to ensight and need help. Simulation: - chtMultiRegionSimpleFoam using two zones: AIR and SOURCE (free convection using heat source) - Under every time step (300as example) two folders are created for every zone normally - Results produced and are viewable using paraFoam Problem: - converting data using foamToEnsight just translate time but no data... - converting data using foamToEnsight -region AIR translate time and date of the AIR zone... - converting data using foamToEnsightParts translate time and all parts but no data (U T p p_rgh)... How could I transfer the parts and all associated data all together? the help of the commands above dont help much Regards Peter

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Building OpenFOAM1.7.0 from source	ata	OpenFOAM Installation	46	March 6, 2022 14:21
Compile calcMassFlowC	aurore	OpenFOAM Programming & Development	13	March 23, 2018 08:43
OpenFOAM without MPI	kokizzu	OpenFOAM Installation	4	May 26, 2014 10:17
Compile problem	ivanyao	OpenFOAM Running, Solving & CFD	1	October 12, 2012 10:31
checking the system setup and Qt version	vivek070176	OpenFOAM Installation	22	June 1, 2010 13:34

All times are GMT -4. The time now is 12:41.