|
[Sponsors] |
![]() |
![]() |
#1 |
Senior Member
harshawardhank
Join Date: Mar 2014
Posts: 209
Rep Power: 13 ![]() |
Hello Friends
I want sample a data over a plane as shown below the plane is highlighted " Not on full plane as we get from point and normal but half or some portion that of the full plane " This is useful to analysis data from LES Last edited by harsha_kulkarni; March 11, 2017 at 23:04. Reason: adding more information |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] Plotting data on a plane in the 3D render view | quantumMag | ParaView | 0 | January 31, 2017 09:16 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Defining a zone for sampling a plane | odellar | OpenFOAM Post-Processing | 1 | October 23, 2014 11:15 |
Problem in sampling data | MOHAMMAD67 | OpenFOAM Post-Processing | 4 | May 1, 2012 02:16 |
write transient data of plane | Fabian | CFX | 2 | June 27, 2005 02:38 |