[MtnRunBeachBum]

Hello everyone,

I'm putting this under post-processing as that's where I found my problem, but I realize its likely a setup issue.

After my simulation is done in OF, when I start stepping through the time steps in Paraview (i.e., move past the first timestep) I find that I do not have any options to plot P or U in any capacity. bring up vector lots just shows straight arrows, where there should be at least some bend to the airflow over my model (aircraft). It almost looks as if P and U were not calculated through the sim.

My initial guess was a not-so-good boundary condition that somehow didn't allow the calculations. Any thoughts? I also cannot bring up the Streamline filter (it's greyed-out) if that's any help.