 |
 |
 |
|
|
|
[Sponsors] | ||||
Using clip filter to acquire smooth interface |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 14, 2015, 12:03
|
Using clip filter to acquire smooth interface
|
#1 |
|
Senior Member
Dongyue Li
Join Date: Jun 2012
Location: Beijing, China
Posts: 849
Rep Power: 18  |
Hello guys,
We know clip and contour can be used to show interface, when I use contour, then I apply smooth filter, then interface can be set quite smooth. But I can not apply smooth filter to clip filter. So how can I get smooth interface on clip module?.... |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
| Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 08:00 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
Linear Mode
