wall shear stress .. PLOT OVER LINE - my results

vitorspadetoventurin · December 6, 2014, 17:13

Friends, I generated wallshearstress files to my simulation (openfoam, set laminar on RASproperties, non-newtonian). In order to plot wallshearstress over line (plot over line), Have I just to plot over line on the wall? for example... plotting the line A-A' as follows...
Screenshot from 2014-12-06 19:00:08.jpg

Then I get:

Screenshot from 2014-12-06 18:47:11.jpg

I try to put the points of plot over line exactly over the wall. Am I right? If yes, Is it the best way to get this graph??

Best regards,
Vitor Spadeto Venturin

vitorspadetoventurin · December 6, 2014, 17:24

when I take away a bit of the wall realized that the graph improved. the plot of the previous results is actually a part of the graph below ( in the below graph, I put exactly on the wall. maybe the line is out of the mesh, some values appear as zero (note the x-axis of both graphs, the first is only part of the second graph):Screenshot from 2014-12-06 19:23:37.jpg

December 6, 2014, 17:13	wall shear stress .. PLOT OVER LINE - my results	#1
vitorspadetoventurin Member vitor spadeto Join Date: Nov 2014 Posts: 51 Rep Power: 12	Friends, I generated wallshearstress files to my simulation (openfoam, set laminar on RASproperties, non-newtonian). In order to plot wallshearstress over line (plot over line), Have I just to plot over line on the wall? for example... plotting the line A-A' as follows... Screenshot from 2014-12-06 19:00:08.jpg Then I get: Screenshot from 2014-12-06 18:47:11.jpg I try to put the points of plot over line exactly over the wall. Am I right? If yes, Is it the best way to get this graph?? Best regards, Vitor Spadeto Venturin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Natural convection in a closed domain STILL NEEDING help!	Yr0gErG	FLUENT	4	December 2, 2019 01:04
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 10:56
1.7.x Environment Variables on Linux 10.04	rasma	OpenFOAM Installation	9	July 30, 2010 05:43
Problem of compilation OF 14Allwmake command not found	erik_d	OpenFOAM Bugs	13	September 13, 2008 22:45
error while compiling the USER Sub routine	CFD user	CFX	3	November 25, 2002 16:16

December 6, 2014, 17:24		#2
vitorspadetoventurin Member vitor spadeto Join Date: Nov 2014 Posts: 51 Rep Power: 12	when I take away a bit of the wall realized that the graph improved. the plot of the previous results is actually a part of the graph below ( in the below graph, I put exactly on the wall. maybe the line is out of the mesh, some values appear as zero (note the x-axis of both graphs, the first is only part of the second graph):Screenshot from 2014-12-06 19:23:37.jpg