 |
 |
 |
|
|
|
[Sponsors] | ||||
February 16, 2012, 06:07
|
sHM layers problem
|
#1 |
|
New Member
Barney Garrood
Join Date: Jan 2012
Posts: 7
Rep Power: 14  |
I am struggling to with layers in snappyHexMesh.
I have a simple model, from which I am trying to grow 6 layers. In areas close to where the surface refinement changes, the number of grown layers reduces, or disappear altogether. The attached shows an example of this (using ExtractCellsByRegion in paraView). I also attach the snappyHexMeshDict. I have tried changing most of the layers settings, but dont really get anywhere. I would much appreciate any advice! Thanks, Barney |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Problem with sHM addLayer | Jinjolee | OpenFOAM Meshing & Mesh Conversion | 8 | April 18, 2019 14:55 |
| [snappyHexMesh] Problem with curves and layers | Ouschen | OpenFOAM Meshing & Mesh Conversion | 1 | January 24, 2019 09:49 |
| Will it be a problem if I use inflation layers at my outlet? This will save me time | noelanish | FLUENT | 4 | April 29, 2017 11:23 |
| [snappyHexMesh] Problem with SnappyHexMesh | Joehin | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2017 12:21 |
| [snappyHexMesh] SHM problem | samy902 | OpenFOAM Meshing & Mesh Conversion | 3 | July 24, 2013 17:51 |
Linear Mode
