[mesh manipulation] using mergeMeshes and stitchMesh

Lada · October 12, 2011, 14:42

I have created two very simple cases consisting of a cube and a cylinder. I have successfully blockmeshed them but I am struggling with joining the cases together.
Actually, I had managed it once and even noted what I did, but apparently I must have missed something as I have not been capable of repeating the whole action and get the joint case running.
Could anyone give me a hint and/or write here the right procedure, please?

tomislav_maric · October 13, 2011, 03:25

Quote:

Originally Posted by Lada

I have created two very simple cases consisting of a cube and a cylinder. I have successfully blockmeshed them but I am struggling with joining the cases together.
Actually, I had managed it once and even noted what I did, but apparently I must have missed something as I have not been capable of repeating the whole action and get the joint case running.
Could anyone give me a hint and/or write here the right procedure, please?

I've written up the procedure in this thread:

http://www.cfd-online.com/Forums/ope...hes-p-t-u.html

Hope it helps!

Tomislav

Lada · October 13, 2011, 16:04

That was it. Thank you Tomislav.
Lada

October 12, 2011, 14:42	using mergeMeshes and stitchMesh	#1
Lada New Member vladimir krejci Join Date: Mar 2009 Location: Czech Republic Posts: 20 Rep Power: 17	I have created two very simple cases consisting of a cube and a cylinder. I have successfully blockmeshed them but I am struggling with joining the cases together. Actually, I had managed it once and even noted what I did, but apparently I must have missed something as I have not been capable of repeating the whole action and get the joint case running. Could anyone give me a hint and/or write here the right procedure, please?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[mesh manipulation] StitchMesh sigFpe / bad point	liquidspoon	OpenFOAM Meshing & Mesh Conversion	2	November 29, 2015 15:19
[mesh manipulation] mergeMeshes and stitchMesh in parallel?	samiam1000	OpenFOAM Meshing & Mesh Conversion	1	June 6, 2014 11:21
[mesh manipulation] Problem with stitchMesh: it does not work in meshes with several common patches	arnau1985	OpenFOAM Meshing & Mesh Conversion	2	June 25, 2013 09:49
[mesh manipulation] stitchMesh and mergeMeshes removal of interfaces	flowris	OpenFOAM Meshing & Mesh Conversion	6	July 16, 2010 13:06
[mesh manipulation] MergeMeshes and stitchMesh problem	flo	OpenFOAM Meshing & Mesh Conversion	6	May 10, 2010 11:40

October 13, 2011, 16:04		#3
Lada New Member vladimir krejci Join Date: Mar 2009 Location: Czech Republic Posts: 20 Rep Power: 17	That was it. Thank you Tomislav. Lada