 |
 |
 |
|
|
|
[Sponsors] | ||||
[blockMesh] Specifying the height of the first cell of a block using simpleGrading |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 16, 2011, 14:15
|
Specifying the height of the first cell of a block using simpleGrading
|
#1 |
|
Member
Alex
Join Date: Jun 2010
Location: Planet Earth
Posts: 43
Rep Power: 16  |
Has anybody come up with a formula to solve the ratio you need for a given first layer height and total block height in blockMesh?
Example: Let's say I'm modeling the flow over a thin plate 4m long as a single block. I want my first layer of cells on the plate to be 0.001m in height. Outside of using multiple blocks, can I specify a certain expansion ratio for a given block height that will give me exactly 0.001m in height on the first layer? |
|
|
|
|
|
June 16, 2011, 14:52
|
|
#2 |
|
Member
Alex
Join Date: Jun 2010
Location: Planet Earth
Posts: 43
Rep Power: 16 |
Nevermind. I found a program that does it in the same forum...
http://www.cfd-online.com/Forums/ope...alculator.html |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] --> FOAM FATAL ERROR: Trying to specify a boundary face | A.A. | OpenFOAM Meshing & Mesh Conversion | 41 | June 26, 2020 08:06 |
| [blockMesh] edges not aligned with or perpendicular to non-empty directions | ynos | OpenFOAM Meshing & Mesh Conversion | 6 | March 26, 2020 16:02 |
| [blockMesh] Openfoam: Meshing, where do my defaultFaces come from | syntex | OpenFOAM Meshing & Mesh Conversion | 19 | December 10, 2018 08:21 |
| Neighboring cells in tetrahedral mesh | vishwesh | OpenFOAM Programming & Development | 9 | November 10, 2017 08:06 |
| [blockMesh] FOAM FATAL ERROR: face 0 in patch 0 does not have neighbour cell face | am9109 | OpenFOAM Meshing & Mesh Conversion | 41 | October 15, 2015 04:59 |
Linear Mode
