 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] Snap the mesh from a level set function instead of a STL surface |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 9, 2011, 16:45
|
Snap the mesh from a level set function instead of a STL surface
|
#1 |
|
New Member
Martine Ginette
Join Date: Feb 2011
Posts: 5
Rep Power: 0  |
Dear everyone,
Is it possible to use snappyHexMesh to cut a mesh at the location of the zero-level-set of some volScalarField? Thanks a lot for your help, Martin. |
|
|
|
|
|
April 5, 2011, 06:38
|
|
#2 |
|
Member
Eysteinn Helgason
Join Date: Sep 2009
Location: Gothenburg, Sweden
Posts: 53
Rep Power: 17 |
I'm also looking if there is some built in tool for this.
Did you get an answer to this question? |
|
|
|
|
|
|
April 5, 2011, 11:21
|
|
#3 |
|
New Member
Martine Ginette
Join Date: Feb 2011
Posts: 5
Rep Power: 0 |
Sadly not...
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 19:57 |
| [snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 08:05 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| [snappyHexMesh] Layers don't fully surround surface | EVBUCF | OpenFOAM Meshing & Mesh Conversion | 14 | August 20, 2012 05:31 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
Linear Mode
