[snappyHexMesh] trailing edge not snapped perfectly.. -- CFD Online Discussion Forums

March 2, 2011, 13:49

trailing edge not snapped perfectly..

ahsangzl

New Member

Ahsan Gasal

Join Date: Feb 2011

Posts: 1

Rep Power: 0

Hi,
I was trying to mesh an airplane without tail in SHM. It takes long time for complete the mesh also the trailing edge is not snapped.. so How can i snap is correctly, my supervisor says to use curvature base control but i dont know how to use it since i am new to OF. I cannot add layers also.. please help.. i have attached pic of trailing edge of the wing and SHMD file

Attached Images

SHM5.jpg (66.2 KB, 64 views)

Attached Files

SHMD.txt (2.5 KB, 12 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
Trailing edge sensitivity anlaysis	JanH	SU2	2	November 23, 2018 14:53
[ICEM] Hole near sharp trailing edge of airplane/wing geometry	jlichtwa	ANSYS Meshing & Geometry	2	September 21, 2010 16:19
Which trailing edge is correct for meshing of aerofoils for CFX	LSC	CFX	0	May 10, 2009 13:45
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

All times are GMT -4. The time now is 13:03.