|
[Sponsors] |
[mesh manipulation] To increase number of cells and faces |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 28, 2010, 14:26 |
To increase number of cells and faces
|
#1 |
Member
Join Date: Nov 2010
Posts: 33
Rep Power: 15 |
I am working on nonnewtonianIcofoam. I refined the mesh using refineMesh utility. The current mesh structure is as follows:
Mesh stats points: 14884 internal points: 0 faces: 29042 internal faces: 14182 cells: 7200 boundary patches: 6 point zones: 0 face zones: 0 cell zones: 0 Overall number of cells of each type: hexahedra: 7180 prisms: 0 wedges: 0 pyramids: 0 tet wedges: 0 tetrahedra: 0 polyhedra: 20 I would like to increase the number of cells and faces in this mesh to a large value (say 200K). Please suggest the way to do it. Thanks !! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Foam::error::PrintStack | almir | OpenFOAM Running, Solving & CFD | 92 | May 21, 2024 08:56 |
Decomposing meshes | Tobi | OpenFOAM Pre-Processing | 22 | February 24, 2023 10:23 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
[OpenFOAM.org] OF2.3.1 + OS13.2 - Trying to use the dummy Pstream library | aylalisa | OpenFOAM Installation | 23 | June 15, 2015 15:49 |
SigFpe when running ANY application in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 23, 2015 15:53 |