|
[Sponsors] |
[Commercial meshers] gambit mesh refinement with openfoam commands problem. |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
Mohammad.R.Shetab
Join Date: Jul 2010
Posts: 49
Rep Power: 16 ![]() |
Dear Foamers
I'm working on a centrifugal fan, with a mesh had been made in Gambit. It is a tetrahedral mesh. I changed it into openfoam format with command fluentMeshToFoam. Does anyone know if I can refine mesh near walls, with openfoam commands like refineMesh or something else. Every answer would be highly appreciated. Thank you Mohammadreza |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Multi Region Mesh of a car filter | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 3 | September 11, 2019 20:34 |
[snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 09:07 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 19:57 |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 04:23 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 20:43 |