[Commercial meshers] gambitToFoam boundary defining problem -- CFD Online Discussion Forums

April 21, 2010, 04:41	gambitToFoam boundary defining problem	#1
maysmech Senior Member Join Date: Jan 2010 Posts: 347 Blog Entries: 2 Rep Power: 17	Hi Foamers, i created a simple cubic by Gambit and by using gambitToFoam command and typing blockMesh the mesh was produced. when i want use laplacianFoam the boundary error occurs. i don't see blockMeshdict file to revise boundaries. there are face, points and ... which i cant define boundary on them. What should i do?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Velocity vector in impeller passage	ngoc_tran_bao	CFX	24	May 3, 2016 22:16
Waterwheel shaped turbine inside a pipe simulation problem	mshahed91	CFX	3	January 10, 2015 12:19
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 05:15
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55

All times are GMT -4. The time now is 05:01.