 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] How can I put snappy layers in a separate cellzone? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 3, 2010, 15:19
|
How can I put snappy layers in a separate cellzone?
|
#1 |
|
New Member
Jonas
Join Date: Apr 2010
Location: Sweden
Posts: 5
Rep Power: 16  |
Hi Foamers,
In Snappy I've tried to put created layers in a separate cellZone, but haven't succeed. I would like to put each patch's layers in a specific cellZone. Have someone accomplished something similar like that, or maybe just a clue or an idea how to do it? Kind Regards, Jonas |
|
|
|
|
|
April 5, 2010, 10:18
|
|
#2 |
|
New Member
Jonas
Join Date: Apr 2010
Location: Sweden
Posts: 5
Rep Power: 16 |
Just to clarify. I have seen that a separate cell set of all cell layers are created during the snappy process. That set can be move into a new cell zone by setsToZones. So I guess that a way could be to first put the cell layers in separate sets and then move them to cell zones.
-Jonas |
|
|
|
|
|
|
| Tags |
| cellzone, layers, snappyhexmesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Trouble with snappy and boundary layers | kellard | OpenFOAM Meshing & Mesh Conversion | 12 | February 12, 2019 06:12 |
| [Salome] SALOME : How to define several CellZone | utawalpa | OpenFOAM Meshing & Mesh Conversion | 0 | March 23, 2018 14:19 |
| [snappyHexMesh] Adding layers goes wrong with SnappyHexMesh | Elise | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 03:32 |
| Layers and turbolence in Interfoam | danvica | OpenFOAM Running, Solving & CFD | 0 | April 30, 2012 04:11 |
| [snappyHexMesh] Extruding layers in snappy deforms internal geometry | overkligheten | OpenFOAM Meshing & Mesh Conversion | 1 | April 7, 2010 09:21 |
Linear Mode
