[blockMesh] basic blockMesh : manipulate the lid-driven cavity flow tutorials

Lexa · October 31, 2009, 00:13

Hi all!
I'm a new user of OpenFoam and have some basic problems with my project using OF 1.6.

referred to the cavity tutorials (lid driven cavity flow), I've added a similar block in the right side, adjacent to the original one. but when I want to see the flow (using paraFoam), the contour is not become one. every block has its own contour plot, but there're similar. so if i want to make 1 contour, what should I do?

any help will be greatly appreciated.. thanks.

gwierink · October 31, 2009, 06:59

Hi Alex,

Should it be one reservoir of liquid or two? Did you change the wall boundary condition of the right wall of the original cavity case? What is the case you would like to simulate? or is it just a postprocessing issue? Just post your blockMeshDict here so we can have a look what it looks like.

Regards,

Gijs

Lexa · November 12, 2009, 22:15

Mmm.. sorry i think i used wrong solver.. so i post a new thread, in this link : http://www.cfd-online.com/Forums/ope...-2-blocks.html.
The problem is still same. The fluid is air..

October 31, 2009, 00:13	basic blockMesh : manipulate the lid-driven cavity flow tutorials	#1
Lexa New Member Alex Christantho Join Date: Oct 2009 Posts: 10 Rep Power: 17	Hi all! I'm a new user of OpenFoam and have some basic problems with my project using OF 1.6. referred to the cavity tutorials (lid driven cavity flow), I've added a similar block in the right side, adjacent to the original one. but when I want to see the flow (using paraFoam), the contour is not become one. every block has its own contour plot, but there're similar. so if i want to make 1 contour, what should I do? any help will be greatly appreciated.. thanks.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Three Dimensional Lid Driven Cavity for high Re Numbers	suhas jain	Main CFD Forum	0	January 7, 2014 02:38
LID driven cavity flow	s_rehman	Main CFD Forum	0	December 24, 2013 01:55
is there any parallel code for the famous Lid Driven Cavity flow?	gholamghar	Main CFD Forum	0	August 1, 2010 02:55
[OpenFOAM] Paraview - Lid Driven Cavity	kieranhood	ParaView	0	February 13, 2010 17:28
Introduction lid driven cavity	deshmukh yogesh	Main CFD Forum	2	November 8, 2006 08:05

October 31, 2009, 06:59		#2
gwierink Senior Member Gijsbert Wierink Join Date: Mar 2009 Posts: 383 Rep Power: 18	Hi Alex, Should it be one reservoir of liquid or two? Did you change the wall boundary condition of the right wall of the original cavity case? What is the case you would like to simulate? or is it just a postprocessing issue? Just post your blockMeshDict here so we can have a look what it looks like. Regards, Gijs

November 12, 2009, 22:15		#3
Lexa New Member Alex Christantho Join Date: Oct 2009 Posts: 10 Rep Power: 17	Mmm.. sorry i think i used wrong solver.. so i post a new thread, in this link : http://www.cfd-online.com/Forums/ope...-2-blocks.html. The problem is still same. The fluid is air..