[mesh manipulation] How does one create a patch on a complex geomtry?

bigphil · September 24, 2009, 06:13

Hi,

Is there some tool or method of defining patches on my geometry?

autoPatch doesn't gives me the right patches as the patches I want to define are not easily recognisable using different angles in autoPatch.

I've searched through the forum and found that 'patchTool' was in version 1.4, and seems to be what I'm looking for, but since it seems to have been discontinued, is there some other newer tool/utility that will do the job?

Or should I just try get patchTool working on 1.4?

How do other people define patches on complex geometries?

Any suggestions are most welcome,

Philip

bigphil · October 9, 2009, 08:40

For anyone else who has the same sort of problem,

I found that patchTool in OF-1.4-dev and earlier does the job, even if it's a bit tedious for finer meshes.

Philip

September 24, 2009, 06:13	How does one create a patch on a complex geomtry?	#1
bigphil Super Moderator Philip Cardiff Join Date: Mar 2009 Location: Dublin, Ireland Posts: 1,097 Rep Power: 34	Hi, Is there some tool or method of defining patches on my geometry? autoPatch doesn't gives me the right patches as the patches I want to define are not easily recognisable using different angles in autoPatch. I've searched through the forum and found that 'patchTool' was in version 1.4, and seems to be what I'm looking for, but since it seems to have been discontinued, is there some other newer tool/utility that will do the job? Or should I just try get patchTool working on 1.4? How do other people define patches on complex geometries? Any suggestions are most welcome, Philip Last edited by bigphil; September 25, 2009 at 13:00.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with cyclic boundaries in Openfoam 1.5	fs82	OpenFOAM	37	November 29, 2024 11:15
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch	gschaider	OpenFOAM Installation	225	August 25, 2015 20:43
Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam)	cfdonline2mohsen	OpenFOAM	3	October 21, 2013 10:28
[mesh manipulation] Using createPatch in place of couplePatches	sripplinger	OpenFOAM Meshing & Mesh Conversion	8	November 13, 2009 08:14
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

October 9, 2009, 08:40		#2
bigphil Super Moderator Philip Cardiff Join Date: Mar 2009 Location: Dublin, Ireland Posts: 1,097 Rep Power: 34	For anyone else who has the same sort of problem, I found that patchTool in OF-1.4-dev and earlier does the job, even if it's a bit tedious for finer meshes. Philip