[mesh manipulation] how to create faceZones?

phsieh2005 · September 2, 2009, 16:28

Hi,

Is it possible to create faceZones out of a box, say (-1 -1 -1)(1 1 1)?

Or, is it possible to convert a faceSet (which I created using setSet, then, faceSet) to faceZones? (the faceSet in under polyMesh/sets)

Thanks!

Pei

phsieh2005 · September 2, 2009, 22:26

Hi,

I found that, if there is only one fluid domain, then, setsToZones can convert faceSets to faceZones. But, I am working on a multiRegion case. It looks like setsToZones cannot handle regions. Any suggestion will be appreciated.

Pei

September 2, 2009, 16:28	how to create faceZones?	#1
phsieh2005 Senior Member Pei-Ying Hsieh Join Date: Mar 2009 Posts: 334 Rep Power: 18	Hi, Is it possible to create faceZones out of a box, say (-1 -1 -1)(1 1 1)? Or, is it possible to convert a faceSet (which I created using setSet, then, faceSet) to faceZones? (the faceSet in under polyMesh/sets) Thanks! Pei

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
create the file *.foam	phongstar	OpenFOAM	12	October 14, 2018 19:06
[snappyHexMesh] SHM doesn't create cellZones for one region	Eko	OpenFOAM Meshing & Mesh Conversion	10	January 24, 2018 03:03
OpenFoam "Permission denied" and "command not found" problems.	iyidaniel@yahoo.co.uk	OpenFOAM Running, Solving & CFD	11	January 2, 2018 07:47
[GAMBIT] How to plot S pipe	mariam.sara	ANSYS Meshing & Geometry	36	November 7, 2013 16:22
[DesignModeler] Design Modeller create surface	papis	ANSYS Meshing & Geometry	0	October 31, 2013 14:52

September 2, 2009, 22:26		#2
phsieh2005 Senior Member Pei-Ying Hsieh Join Date: Mar 2009 Posts: 334 Rep Power: 18	Hi, I found that, if there is only one fluid domain, then, setsToZones can convert faceSets to faceZones. But, I am working on a multiRegion case. It looks like setsToZones cannot handle regions. Any suggestion will be appreciated. Pei