[snappyHexMesh] snappyHex: halfmodel with BL and symmetryPlane

Rene · April 29, 2009, 06:03

Dear all,

i have a question regarding snappyHexMesh. It works quite well so far but i have a problem when i try to mesh a halfmodel with a symmetryplane and boundary layers.

What happens is, that the boundary layer stopps before reaching the symmetry plane. Is there any option or trick to use that the BL does not stop there? Please see picture attached (green is the symmetryPlane, grey is a simple halfsphere).

Thanks,

René

wolle1982 · April 30, 2009, 06:57

No chance! There will always be this problem near symmetryPlanes. Wait until next sHM version is out. They fixed a whole bunch of problems.

April 30, 2009, 06:57		#2
wolle1982 Senior Member Wolfgang Heydlauff Join Date: Mar 2009 Location: Germany Posts: 136 Rep Power: 21	No chance! There will always be this problem near symmetryPlanes. Wait until next sHM version is out. They fixed a whole bunch of problems.