 |
 |
 |
|
|
|
[Sponsors] | ||||
February 7, 2006, 10:20
|
Cyclic boundaries
|
#1 |
|
Member
diablo80@web.de
Join Date: Mar 2009
Posts: 93
Rep Power: 17  |
Is it possible to generate cyclic physical boundaries in gmsh and/or reorder the faces number generated in gmsh so that OF can deal with the mesh?
Or else, how can one build a OF cyclic geometry out of a gmsh mesh? Thanks a lot. |
|
|
|
|
|
February 7, 2006, 14:26
|
Try the createPatch utility. I
|
#2 |
|
Senior Member
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,419
Rep Power: 26 |
Try the createPatch utility. It only takes care of the face ordering however, it does require GMSH to have produced a mesh with exactly same faces on opposite sides.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mapped vs Cyclic Boundaries in OpenFOAM | arsenis | OpenFOAM Running, Solving & CFD | 1 | February 8, 2023 22:13 |
| [mesh manipulation] Problem with using createPatchDict to define cyclic boundaries | kaszt | OpenFOAM Meshing & Mesh Conversion | 0 | April 1, 2016 22:18 |
| No flow through periodic (cyclic) boundaries in impeller with foam-extend-3.1 | anttiad9000 | OpenFOAM Running, Solving & CFD | 3 | March 2, 2016 20:37 |
| Possible createPatch/createBaffles bug? | simpomann | OpenFOAM Bugs | 2 | July 15, 2014 08:07 |
| Wrong wall distance with cyclic boundaries | sebastian | OpenFOAM Bugs | 4 | October 31, 2012 11:24 |
Linear Mode
