 |
 |
 |
|
|
|
[Sponsors] | ||||
[blockMesh] Problem with blockMesh and cyclics |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 25, 2006, 06:34
|
Problem with blockMesh and cyclics
|
#1 |
|
Senior Member
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,419
Rep Power: 26  |
checkMesh tells me that your mesh and cyclics are topologically ok. However the mesh is not very good , there are lots of distorted cells (max. non-orthogonality, max skewness). Try your problem with a better mesh with the same topology.
|
|
|
|
|
|
May 26, 2006, 07:41
|
Mattijs,
Thanks for your re
|
#2 |
|
New Member
Rikard Mikalsen
Join Date: Mar 2009
Posts: 10
Rep Power: 17 |
Mattijs,
Thanks for your reply. I improved the mesh and now it all looks a lot better. It was indeed my very poor original mesh that was the problem, not the coupling of the cyclics. Regards, Rikard |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Actuator Disk Implementation Problem | tareqkh | OpenFOAM Programming & Development | 0 | June 26, 2015 05:47 |
| Actuator Disk Implementation Problem | tareqkh | OpenFOAM Programming & Development | 0 | June 25, 2015 04:43 |
| No "neighbourPatch" provided. Is your mesh uptodate with split cyclics? | OF-User | OpenFOAM Pre-Processing | 3 | April 10, 2014 07:41 |
| [snappyHexMesh] snappyHexMesh in parallel with cyclics | tonyuprm | OpenFOAM Meshing & Mesh Conversion | 1 | June 29, 2011 11:43 |
| [mesh manipulation] Problem with cyclic patch and createPatch | mattijs | OpenFOAM Meshing & Mesh Conversion | 12 | August 24, 2006 05:57 |
Linear Mode
