 |
 |
 |
|
|
|
[Sponsors] | ||||
[mesh manipulation] Mesh Generation for Simple geometry |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 15, 2007, 15:22
|
Mesh Generation for Simple geometry
|
#1 |
|
Guest
Posts: n/a
|
I would like to build a 3D smoke stack simulation for my College project. How should i start defining the geometry and how should i prepare the mesh for solving with OpenFOAM.
|
|
|
||
|
July 11, 2007, 07:06
|
Go through the three tutorials
|
#2 |
|
Senior Member
Srinath Madhavan (a.k.a pUl|)
Join Date: Mar 2009
Location: Edmonton, AB, Canada
Posts: 703
Rep Power: 21  |
Go through the three tutorials (lid-driven cavity, dam break and stress analysis) and try to follow blockMesh usage, the grid generator for OpenFOAM. Search the blockMesh forum for hints/tips. If your queries are not discussed there, post a message in the appropriate forum. Someone will help you. Some useful resources can be found in the wiki[1,2]
[1] http://openfoamwiki.net/index.php/Tut_wendel_cavity [2] http://openfoamwiki.net/index.php/Tut_wendel_catia |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] CATIA Geometry Generation and Meshing | danielsullivan | ANSYS Meshing & Geometry | 0 | April 3, 2017 22:11 |
| Mesh generation for a geometry | raunakjung | Mesh Generation & Pre-Processing | 0 | February 9, 2017 22:28 |
| [GAMBIT] mesh generation and geometry creation packed bed reactors | manuc | ANSYS Meshing & Geometry | 6 | April 12, 2016 03:24 |
| Geometry and mesh generation in OpenFoam | pokeng | OpenFOAM Pre-Processing | 1 | October 28, 2011 22:40 |
| 3-d elliptic generation mesh | Gang Sun | Main CFD Forum | 5 | September 16, 1998 01:24 |
Linear Mode
