[blockMesh] Creating a circular inlet on a wall boundary face in OpenFOAM? -- CFD Online Discussion Forums

February 15, 2024, 21:03	Creating a circular inlet on a wall boundary face in OpenFOAM?	#1
Bhoot New Member bhoot Join Date: Apr 2020 Posts: 1 Rep Power: 0	Hi, Is it possible to create a circular inlet in a 2d wall boundary face? Keywords: OpenFOAM, topoSetDict, createPatchDict. Thanks in advance.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
Table bounds warnings at: END OF TIME STEP	CFXer	CFX	4	July 17, 2020 00:44
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 07:28
[blockMesh] BlockMeshmergePatchPairs	hjasak	OpenFOAM Meshing & Mesh Conversion	11	August 15, 2008 08:36

All times are GMT -4. The time now is 05:25.