 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] Snapping to baffle or internal face zone |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 31, 2023, 08:08
|
Snapping to baffle or internal face zone
|
#1 |
|
Member
Tuomo Keskitalo
Join Date: Oct 2010
Posts: 57
Rep Power: 16  |
Hi,
I'm testing Snappy for meshing this helical mixer vessel: Screenshot_2023-12-31_09-00-23.jpg I'm using face zones for the highlighted helix surfaces (no thickness) then adding layers on them. However, my main question is about snapping to helix surface edges: I wonder is it possible to get a smooth snapping on the righmost (see below) curve where block mesh cells are not aligned with the helix edges? I've tried to relax quite a few quality criteria. There is some improvement but there are always some kinks. I suppose this is more of a beauty issue, but still. Here's an example: Screenshot_2023-12-31_09-01-55.jpg BR, Tuomo |
|
|
|
|
|
| Tags |
| baffle, face zone, snapping |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Seakeeping Solver:Crashed | akbarbagusd | Fidelity CFD | 0 | November 5, 2021 13:42 |
| [Commercial meshers] Mesh conversion problem (fluent3DMeshToFoam) | Aadhavan | OpenFOAM Meshing & Mesh Conversion | 2 | March 8, 2018 02:47 |
| snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 11:58 |
| [blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 06:42 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 10:56 |
Linear Mode
