 |
 |
 |
|
|
|
[Sponsors] | ||||
[blockMesh] Refinement region gradiant is very abrupt |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 16, 2023, 15:12
|
Refinement region gradiant is very abrupt
|
#1 |
|
New Member
Join Date: May 2023
Posts: 4
Rep Power: 3  |
Hi to all,
I am running a very basic outdoor comfort simulation. However, when I try to perform the CFD with butterfly, the refinement region border of the BBOX becomes very abrupt. I wonder if I am doing something wrong, or if this is how it should be. Could anybody help me to point out where is my mistake or how to fix it? Have you faced this issue before? Thanks |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh running killed! | Mark JIN | OpenFOAM Meshing & Mesh Conversion | 7 | June 14, 2022 02:37 |
| [snappyHexMesh] Multi Region Mesh of a car filter | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 3 | September 11, 2019 20:34 |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 18:16 |
| [snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 10:42 |
| p_rgh initial residual no change with different settings | manuc | OpenFOAM Running, Solving & CFD | 3 | June 26, 2018 16:53 |
Linear Mode
