 |
 |
 |
|
|
|
[Sponsors] | ||||
[blockMesh] Creating a Patch on AachenBomb Mesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 3, 2023, 07:27
|
Creating a Patch on AachenBomb Mesh
|
#1 |
|
New Member
Valerio
Join Date: Apr 2023
Posts: 4
Rep Power: 3  |
Hello everyone,
I need some advice on creating a patch on the aachenBomb mesh. Specifically, I need to create a patch where the injector is located to simulate a dense regime fuel jet (high pressure, hence no spray regime). I was advised to use topoSet, but I am having trouble figuring it out. Do you have any suggestions? Thanks in advance |
|
|
|
|
|
| Tags |
| dense, mesh, patch, toposet |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Fluent msh and cyclic boundary | cfdengineering | OpenFOAM Meshing & Mesh Conversion | 49 | November 29, 2024 22:16 |
| [OLAFLOW] The OLAFLOW Thread | Phicau | OpenFOAM Community Contributions | 459 | September 12, 2024 12:47 |
| Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 14:48 |
| [Other] How to create an MRF zone ? | aminem | OpenFOAM Meshing & Mesh Conversion | 2 | December 8, 2014 11:45 |
| [blockMesh] Cyclic BC's: Possible face ordering problem? (Channel flow) | sega | OpenFOAM Meshing & Mesh Conversion | 3 | September 28, 2010 13:46 |
Linear Mode
