|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Seyfi Girgin
Join Date: Aug 2015
Posts: 12
Rep Power: 11 ![]() |
Hi everyone,
I am new to stitchMesh and want to learn about it. I have two patches, they perfectly match each other. I want to combine them and so that I will create 1 patch. What is the way of using stitchMesh command. Could someone describe this to me? Lets say I have patch1.msh and patch2.msh What would be the entire command line like? Regards, |
|
![]() |
![]() |
![]() |
Tags |
mesh, stitchmesh |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Residual faces after stitchMesh | Woud | OpenFOAM Meshing & Mesh Conversion | 0 | September 23, 2021 07:30 |
[mesh manipulation] stitchMesh Not Working Properly | leuthar | OpenFOAM Meshing & Mesh Conversion | 2 | November 30, 2020 07:30 |
[mesh manipulation] stitchMesh perfect vs partial | Eloise | OpenFOAM Meshing & Mesh Conversion | 2 | October 25, 2017 10:47 |
[mesh manipulation] stitchMesh: multiple meshes | GerhardHolzinger | OpenFOAM Meshing & Mesh Conversion | 3 | August 25, 2017 12:43 |
[mesh manipulation] StitchMesh sigFpe / bad point | liquidspoon | OpenFOAM Meshing & Mesh Conversion | 2 | November 29, 2015 14:19 |