 |
 |
 |
|
|
|
[Sponsors] | ||||
September 9, 2022, 08:24
|
Extrusion with dilation
|
#1 |
|
Senior Member
Nico
Join Date: Jan 2022
Location: Germany
Posts: 122
Rep Power: 6  |
Hi, is it possible to extrude a transfinite surface of an rectangle with lengths a x b in such a way that the end surface has the lengths a x (b x n) [n<1]? (See attached image)
The outer left surface is the one i want to extrude with the right outer surface being the end of the extrusion. I would like to use it to construct structured meshes for a fluid. Thank you and have a nice day! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mesh Extrusion + Porous Block Extrusion | uwastudent | STAR-CCM+ | 2 | May 1, 2018 20:19 |
| Skew on the extrusion around the near wingtip region | Chock767 | Pointwise & Gridgen | 0 | October 26, 2016 13:55 |
| Divergence / Convergence for different inlet extrusion lengths | Janshi | STAR-CCM+ | 8 | October 27, 2011 11:32 |
| Difficult ICEMCFD question: Extrusion | Walter | CFX | 11 | April 19, 2011 03:22 |
| Extrusion Modeling | Elliot Schwartz | Main CFD Forum | 1 | September 11, 1998 20:08 |
Linear Mode
