 |
 |
 |
|
|
|
[Sponsors] | ||||
April 12, 2021, 16:21
|
Patch not being formed
|
#1 |
|
New Member
Skanda
Join Date: Feb 2021
Posts: 11
Rep Power: 5  |
Hey, I have tried to make a mesh using snappy hex mesh. When I finish meshing it says meshed without any errors but when I go into my polymesh folder and the boundary file, I can only see the patches formed by block mesh the patch that has to be formed due to the stl file is not being formed. Any suggestions?
Thank you. |
|
|
|
|
|
April 12, 2021, 20:14
|
|
#2 |
|
Senior Member
Claudio Boezio
Join Date: May 2020
Location: Europe
Posts: 137
Rep Power: 7 |
Hi, I suggest you let us see your snappyHexMeshDict.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OLAFLOW] The OLAFLOW Thread | Phicau | OpenFOAM Community Contributions | 459 | September 12, 2024 12:47 |
| y+ and u+ values with low-Re RANS turbulence models: utility + testcase | florian_krause | OpenFOAM | 114 | August 23, 2023 06:37 |
| steadyUniversalMRFFoam Tutorial fails in MixingPlane | HenrikJohansson | OpenFOAM Bugs | 0 | February 14, 2019 05:48 |
| Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 14:48 |
| [Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 09:19 |
Linear Mode
