 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] Convergent layers with different patches |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 3, 2021, 12:14
|
Convergent layers with different patches
|
#1 |
|
Member
Cpt. Convergence
Join Date: Feb 2020
Posts: 98
Rep Power: 8  |
Dear all,
I am trying to mesh a wing with a pylon in snappyHexMesh but I acknowledged that when I create the layers, they do not combine in the boundaries of my 2 patches (wing_wing and wing_pylon) as you can see in the attached screenshots. Since each patch has a different name I am referring to each of them as : // Beginning of SHM dict.... layers { wing_wing { nSurfaceLayers 6; } wing_pylon { nSurfaceLayers 6; } } // Other options below.... Should I put both surfaces in the same patch so the layers merge in this corner? |
|
|
|
|
|
April 5, 2021, 10:33
|
|
#2 |
|
Senior Member
M
Join Date: Dec 2017
Posts: 698
Rep Power: 12 |
Read the available documentation on the featureAngle specified in addLayersControls.
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Foam::error::PrintStack | almir | OpenFOAM Running, Solving & CFD | 92 | May 21, 2024 08:56 |
| Problem using AMI | vinz | OpenFOAM Running, Solving & CFD | 298 | November 13, 2023 09:19 |
| [snappyHexMesh] snappyHexMesh error "Cannot determine normal vector from patches." | lethu | OpenFOAM Meshing & Mesh Conversion | 1 | June 3, 2020 08:49 |
| Possible bug with stitchMesh and cyclics in OpenFoam | Jack001 | OpenFOAM Pre-Processing | 0 | May 21, 2016 09:00 |
| [snappyHexMesh] avoiding bump on patches with no layers | student666 | OpenFOAM Meshing & Mesh Conversion | 0 | May 5, 2015 13:18 |
Linear Mode
