 |
 |
 |
|
|
|
[Sponsors] | ||||
[mesh manipulation] help!!problem in openfoam when i use icem mesh file with cyclic boundary condition |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 3, 2020, 23:09
|
help!!problem in openfoam when i use icem mesh file with cyclic boundary condition
|
#1 |
|
New Member
wangh
Join Date: Jul 2020
Posts: 10
Rep Power: 6  |
my openfoam version is 2.0
when i use ansys icem make a mesh file and fluent3DMeshToFoam,is ok. but the solver cannot keep going,it print this: FAOM FATAL ERROR: face 9912 area does not matchneighbor by 9.142%--possible face ordering problem . this face area is the boundary which i set cyclic condition . though i used createPatch code,it does not work,the same problem it print out. please help me |
|
|
|
|
|
| Tags |
| cyclic boundary condition, icem, mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] Tabulated thermophysicalProperties library | chriss85 | OpenFOAM Community Contributions | 62 | October 2, 2022 04:50 |
| help!!problem in openfoam when i use icem mesh file with cyclic boundary condition | heheda | Main CFD Forum | 0 | December 3, 2020 23:07 |
| help!!problem in openfoam when i use icem mesh file with cyclic boundary condition | heheda | OpenFOAM Pre-Processing | 0 | December 3, 2020 23:06 |
| what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 02:22 |
| ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 12:46 |
Linear Mode
