 |
 |
 |
|
|
|
[Sponsors] | ||||
[Gmsh] Compound mesh for chtMultiRegionFoam using Gmsh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 27, 2019, 01:53
|
Compound mesh for chtMultiRegionFoam using Gmsh
|
#1 |
|
New Member
Join Date: Dec 2015
Posts: 20
Rep Power: 10  |
Hi,
I have generated meshes for two solid regions and one fluid region separately using gmsh. My doubt is how do I make compound mesh for chtMultiRegionFoam using gmsh? In salome, we can mesh separately each region and using build compound mesh option, we can generate it. Is there any option in Gmsh. Thanks Archana |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GMSH extrude a boundary layer from an unstructured Mesh | Hillie | Mesh Generation & Pre-Processing | 2 | July 7, 2017 04:38 |
| [Gmsh] gMsh instead of blockMesh for base mesh, then snappyHexMesh | sazabi2001 | OpenFOAM Meshing & Mesh Conversion | 0 | February 23, 2017 13:00 |
| Gmsh vs. Pointwise mesh. | paka | Mesh Generation & Pre-Processing | 1 | June 13, 2015 01:53 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 10:03 |
| [Gmsh] gmshToFoam problem: not the same mesh in Gmsh vs. paraview | zhernadi | OpenFOAM Meshing & Mesh Conversion | 8 | July 7, 2011 03:28 |
Linear Mode
