|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Nguyen Minh Quan
Join Date: Feb 2019
Posts: 2
Rep Power: 0 ![]() |
Hi everyone,
I'm having hard time to use snappyHexMesh, I created successfully the mesh, but my domain seem to be cut by some lines (see global_view image) that leave bad quality mesh (see zoom image). Therefore the step add patch can't add cell properly. Thank you for your help. |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
shantanu mandhane
Join Date: Jun 2018
Posts: 10
Rep Power: 8 ![]() |
Did you find a solution to this?
__________________
Regards! Shantanu |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] refineWallLayer Error | Yuby | OpenFOAM Meshing & Mesh Conversion | 2 | November 11, 2021 11:04 |
[mesh manipulation] refineMesh Error | mohsen.boojari | OpenFOAM Meshing & Mesh Conversion | 3 | March 1, 2018 22:07 |
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |