 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] snappyHexMesh remove cells in the edges |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 13, 2018, 11:13
|
snappyHexMesh remove cells in the edges
|
#1 |
|
New Member
samuel
Join Date: Sep 2018
Posts: 5
Rep Power: 8  |
Hi
 I get an issue with snappy, some cells are removed in the edges and i'm afraid it can affect my results. checkMesh gives good results (mesh ok) Regards, Samuel |
|
|
|
|
|
December 20, 2018, 04:20
|
|
#2 |
|
New Member
samuel
Join Date: Sep 2018
Posts: 5
Rep Power: 8 |
For your information, the problem come during the layer process.
However, there is strange results on cells at the edges after snapp process. Last edited by samuel_rff; December 21, 2018 at 03:33. |
|
|
|
|
|
|
| Tags |
| cells, cells removed, remove, snappyhexmesh, snappyhexmesh cells |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cellZone not taking all the cells inside | rahulksoni | OpenFOAM Running, Solving & CFD | 6 | January 25, 2019 01:11 |
| [snappyHexMesh] snappyHexMesh does not remove internal cells | Manyway | OpenFOAM Meshing & Mesh Conversion | 1 | December 14, 2016 19:57 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 09:54 |
| [snappyHexMesh] Remove snappyHexMesh bad cells (subSetMesh) | jet_engine | OpenFOAM Meshing & Mesh Conversion | 1 | June 24, 2016 10:31 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 20:43 |
Linear Mode
