 |
 |
 |
|
|
|
[Sponsors] | ||||
[Commercial meshers] Periodic hill mesh error |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 31, 2018, 05:36
|
Periodic hill mesh error
|
#1 |
|
New Member
Matteo Montecchia
Join Date: Jun 2016
Location: Stockholm
Posts: 1
Rep Power: 0  |
Dear all,
I've done several meshes of a periodic hill (with a different number of grid points) on Pointwise, and for all of them OpenFOAM (using checkMesh) gives the same and only error: Error in coupled point location ... Average mismatch 0. I tried to run my LES anyway, but indeed the Courant Number gets too large. Has somebody faces this problem before? Could it be a mesh problem or a problem on the numerical setup in OF? Thanks in advance. Matteo |
|
|
|
|
|
| Tags |
| les, openfoam, periodic hills |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compile calcMassFlowC | aurore | OpenFOAM Programming & Development | 13 | March 23, 2018 08:43 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit) | Yogini | Fluent UDF and Scheme Programming | 7 | October 3, 2012 08:24 |
| How to install CGNS under windows xp? | lzgwhy | Main CFD Forum | 1 | January 11, 2011 19:44 |
| How to get the max value of the whole field | waynezw0618 | OpenFOAM Running, Solving & CFD | 4 | June 17, 2008 06:07 |
Linear Mode
