 |
 |
 |
|
|
|
[Sponsors] | ||||
November 16, 2017, 16:25
|
empty boundary condition
|
#1 |
|
Senior Member
|
Hi all,
i have a question about using empty boundary condition. if i use empty boundary condition in z direction for example, should i make one cell only in z direction while establishing my mesh, or could i make it more than one cell? i know that technically, no mean to make it more than one, but i ask if it could affect the calculations? thanks |
|
|
|
|
|
December 29, 2017, 10:21
|
|
#2 |
|
Senior Member
Peter Hess
Join Date: Apr 2011
Location: Austria
Posts: 250
Rep Power: 17  |
Marhaba Ahmed!
openFoam as I know dont recognize 2D Mesh! well, yes at least on cell must be in this direction. See cavitiy tutorial. It has one cell in empty direction. Salam Peter |
|
|
|
|
|
 |
| Tags |
| boundary conditionm, empty |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 14:55 |
| Constant mass flow rate boundary condition | sahm | OpenFOAM | 0 | June 20, 2018 23:45 |
| My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 02:44 |
| Out File does not show Imbalance in % | Mmaragann | CFX | 5 | January 20, 2017 11:20 |
| Radiation interface | hinca | CFX | 15 | January 26, 2014 18:11 |
Linear Mode
