 |
 |
 |
|
|
|
[Sponsors] | ||||
July 13, 2017, 08:36
|
Layer colapse befor trailingedge?
|
#1 |
|
New Member
David Buechner
Join Date: Jul 2017
Posts: 2
Rep Power: 0  |
Hello,
short discription of my problem. I meshed a bit complicated airfoil with SnappyHexMesh and got a problem with my TrailingEdge. As you can see the layers are well resolved but just before the trailingedge they colapse. Itīs also recognizable that I used a refinment cylinder to resolve the trailingedge in a better way. Is there a way to get clean layers until the refinment cylinder? I played with featureAngle and slipFeature Angle both didnīt work satisfactory for me. |
|
|
|
|
 |
| Tags |
| layer, snappyhexmesh, trailing edge |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Help with Snappy: no layers growing | GianF | OpenFOAM Meshing & Mesh Conversion | 2 | September 23, 2020 09:26 |
| [snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 06:53 |
| Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 08:48 |
| [snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 14:47 |
| errors | Fahad | Main CFD Forum | 0 | March 23, 2004 14:20 |
Linear Mode
