[Commercial meshers] Mesh conversion .gtm to OpenFOAM

ansab · December 1, 2016, 12:35

Hello respected members,

I have a mesh created using ANSYS Turbogrid and I can save it in either .cgns or .gtm format.

As I want to convert this mesh now in OpenFOAM to perform simulation in OpenFOAM, can anybody guide me in this regard. Can we convert .gtm files using CFX4toFOAM command ? or is there any way to convert .cgns files into OpenFOAM format. Please help me I am stuck.

Any kind of help is appreciated.

Thanks in Advance

ansab · December 4, 2016, 10:25

anybody can help?

tareqkh · December 6, 2016, 14:48

Hello,

In my personal experience, there are some cases you could to that trick FluentToFoam etc. However, openFoam excepts files that are extruded by a factor of one, which I don't know in your case you have that or not. Since you will be using OpenFoam, I would suggest to use one of those open-source mesh tools. I personally have a year experience with gmsh and feel that you can switch your mesh into it easily. I can help you with that if you want.

Cheers,,

December 1, 2016, 12:35	Mesh conversion .gtm to OpenFOAM	#1
ansab New Member Honey Join Date: Jun 2015 Posts: 9 Rep Power: 11	Hello respected members, I have a mesh created using ANSYS Turbogrid and I can save it in either .cgns or .gtm format. As I want to convert this mesh now in OpenFOAM to perform simulation in OpenFOAM, can anybody guide me in this regard. Can we convert .gtm files using CFX4toFOAM command ? or is there any way to convert .cgns files into OpenFOAM format. Please help me I am stuck. Any kind of help is appreciated. Thanks in Advance

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 06:38
Openfoam mesh conversion	harsha_kulkarni	SU2	0	September 16, 2018 03:57
[Commercial meshers] Problems with ANSYS mesh conversion	tdog	OpenFOAM Meshing & Mesh Conversion	1	March 31, 2016 18:36
Suggestion for a new sub-forum at OpenFOAM's Forum	wyldckat	Site Help, Feedback & Discussions	20	October 28, 2014 10:04
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

December 4, 2016, 10:25		#2
ansab New Member Honey Join Date: Jun 2015 Posts: 9 Rep Power: 11	anybody can help?

December 6, 2016, 14:48		#3
tareqkh Senior Member CFD Join Date: Nov 2010 Location: United States Posts: 243 Rep Power: 17	Hello, In my personal experience, there are some cases you could to that trick FluentToFoam etc. However, openFoam excepts files that are extruded by a factor of one, which I don't know in your case you have that or not. Since you will be using OpenFoam, I would suggest to use one of those open-source mesh tools. I personally have a year experience with gmsh and feel that you can switch your mesh into it easily. I can help you with that if you want. Cheers,,